Application of cutting fluid ppt

Rating: 4.16 / Views: 660
2019-10-22 21:10

A TUTORIAL ON CUTTING FLUIDS IN MACHINING Introduction to Cutting Fluids Cutting Fluid Application Strategies Cutting Fluid Effects in MachiningIn the last decade a lot has been discussed about the suitability of using cutting fluid in abundance to cool and lubricate machining processes. application of cutting fluid ppt

Cutting fluid should work just as a coolant for the tool, but the regular process of application makes the fluid to reach all chip formation zones, cooling also the workpiece.

application of cutting

Cutting Fluids WHAT ARE THE CUTTING FLUIDS AS COOLANTS If a cutting fluid performs its lubricating the nature of the application and the material (ii) Identify the purposes of application of cutting fluid in machining (iii) Ascertain the essential properties of cutting fluids (iv) Illustrate the principle of cutting fluid action (v) Classify the types of cutting fluids and state their application (vi) Demonstrate the methods of application of cutting fluid in machining and grinding.application of cutting fluid ppt 5. 6 CUTTING FLUIDS Introduction Cutting fluid (coolant) is any liquid or gas that is applied to the chip andor cutting tool to improve cutting performance. A very few cutting operations are performed dry, i. e. , without the application of cutting fluids. Generally, it is essential that cutting fluids be applied to all machining operations.

Free Application of cutting fluid ppt

Review of Metal Cutting (Shear) Process PowerPoint PPT presentation free to view Cardiovascular System Cardiovascular System Anatomy and Physiology Two children were sitting outside a clinic. application of cutting fluid ppt Cutting fluid may be applied to a cutting toolworkpiece interface through manual, flood or mist application. Manual application simply consists of an operator using a container, such as an oil can, to apply cutting fluid to the cutting toolworkpiece. Cutting oils and water miscible types of cutting fluids are the most widely used. Compressed air, ineIi gases like carbon dioxide, Freon, and Nitrogen are sometimes used. A vortex tube may be used to apply gaseous lubricants or coolants (ARTX, 2002). A REVIEW ON SELECTION OF CUTTING FLUIDS This causes increased cutting fluid loss by dragout and can extend their machining application range to include